MATERIAL SAFETY DATA SHEET
Manufacturers Name: Slickote Coatings Date Prepared: 10/28/99
Street Address: 244 E. Pomona Ave. Monrovia CA 91016
Emergency No.: 1- 800-421-2849 Information: 626-358-1151
Product Class: Solid Film Lubricant V.O.C.: 3.3 Lbs/Gal (400g/l)
Product Name: Slickote HT
INGREDIENTS/ IDENTITY INFORMATION
NIOSH (RTECS) AL3150000
OSHA PEL: 1000 ppm
ACGIH TLV 750 ppm
NIOSH (RTECS) XS914500
OSHA PEL: not established
ACGIH TLV not established
NIOSH (RTECS) MD96596000
OSHA PEL: 15 mg/m3 as dust
ACGIH TLV 2 mg/m3 as dust
Xylene (SARA III)
NIOSH (RTECS) ZE2100000
OSHA PEL: 100 ppm/ 150 STEL
ACGIH TLV 100 ppm/ 150 STEL
PHYSICAL CHEMICAL CHARACTERISTICS
Physical Form : Liquid
Color : n/a
Odor : Slight Solvent
pH : n/a
Boiling Point : Approx. 133 deg F (Acetone)
Melting/Freezing Point : n/k
Solubility in Water : not soluable
Specific Gravity : .98
Bulk Density : 8.26 Lbs/gal
% Volatile by Weight : 78%
Vapor Pressure : 184 mm/Hg (Acetone)
FIRE & EXPLOSION HAZARD DATA
Flash Point : -15 deg F (Acetone)
Upper Explosive Limit (UEL) (%) : 13.0% (Acetone)
Lower Explosive Limit (LEL) (%) : 2.0% (Acetone)
Auto-Ignition Temperature : no data
Extinguishing Media : Dry Chemical; Carbon Dioxide; Form; Water
Special Fire Fighting Procedures : Full emergency equipment with self-contained breathing apparatus and full protective clothing should be worn by firefighters. During a fire, irritating, highly toxic gases may be generated by thermal decomposition or combustion.
Unusual Fire / Explosion Hazards : Isolate from heat, electrical equipment, sparks and open flame. Closed container may explode when contaminated with water (CO2 evolved). Solvent vapors may be heavier than air.
Stagnant air may cause vapors to build up and travel along the ground to an ignition source which may result in a flash back to the source of the vapors
This product is stable.
Conditions to avoid: strong oxidizers
Incompatibility: Coagulation may occur following freezing, thawing or boiling.
Hazards polymerization: None
HEALTH HAZARD DATA
Acute Hazard: Burning, tearing, drying or cracking of skin, coughing, chest pain, difficulty in breathing, nausea, vomiting, abdominal discomfort, diarrhea. Medical conditions generally aggravated by exposure-any respiratory or skin condition
Possible routes of entry: inhalation, ingestion, skin absorption
Emergency and first aid procedures: Eyes: Flush with water for 15 minutes. Skin: Wash with soap and water, not with solvents. Inhalation: Remove to fresh air from exposure area., give CPR if necessary. Ingestion: Do not induce vomiting. In all cases, obtain immediate medical attention.
Carcinogenicity: NTP: No IARC: No OSHA: No
HMIS: Health: 2 Flammability: 3 Reactivity: 0
PRECAUTIONS FOR SAFE HANDLING AND USE
Precautions to be taken in handling storage:
Keep containers closed when not in use. Do not store above (115 deg. F ) keep from freezing. Empty containers may contain product residue. Do not cut, puncture or weld containers. All label warning must be observed, until container has been cleaned or reconditioned, or properly disposed of. Mix material well to proper specifications.
Spills: Wear air supplied NIOSH approved respirator for major unventilated release. Cover with absorbent material and keep loosely covered for 48 hours. Clean up residue with water.
Ventilate area; remove spills with inert absorbent.
Waste disposal method: Dispose in chemical disposal area or in a manner that complies with local state and federal regulations, do not incinerate closed containers.
Use protective gloves, chemical splash safety glasses, and protective resistant apron.
DOT ID#: UN1263
DOT proper shipping name: Paint or Paint Related Material
DOT Label: Flammable Liquid
DOT Class : 3